Working from top to bottom, use our dust products dry.
For hard-to-reach areas
To pick up dust and dirt from narrow and hard-to-reach areas use the Dust Flexi Complete.
Step 1
Slide the Dust Flexi Fibre onto the metal securing with the elastic tab over the hook at the base.
Step 2
Bend the Dust Flexi to fit the area as required then slide along surface to remove dust.
Step 3
To access high surfaces, attach Dust Flexi to the Telescopic Pole. Slide the e-Clip out of the Cap at the bottom of the Dust Flexi handle. Twist and pull to remove the Cap. Insert the Dust Flexi into the Telescopic Pole, align the holes and re-insert the e-Clip to lock in place.
For large flat surfaces
To lift and trap dust and dirt from large, flat surfaces, use the Multi Tool Hardware and Dust Multi Tool Fibre.
Step 1
Place the Dust Multi Tool Fibre on to a table (Fibre side down with label on right hand side). Holding the left side of the Fibre, slide the Multi Tool Hardware Plate into the right hand side of the Fibre, using the raised tab lift the left side of the Fibre over the Multi Tool Plate to secure in place.
Step 2
For high, hard-to-reach surfaces, attach the Multi Tool to the Twister and Telescopic Pole. Slide the e-Clip out of the Cap at the bottom of the Multi Tool handle. Twist and pull to remove the Cap. Insert the Twister, aligning the holes and re-insert the e-Clip to lock in place. Insert the Telescopic Pole into the Twister sliding the yellow ring upwards to lock in place. Push the button on the side of the Twister to adjust angle as required.
For smaller areas
Step 1
Slide the Dust Glove along surfaces to pick up dust, dirt and hair.
For floors
Step 1
To assemble the Floorcleaner, place the Floorcleaner Head on the floor with the collar pushed down. Guide Telescopic Pole into the collar. Twist clockwise until it clicks in place.
Step 2
Place the Dust Floor Fibre on the floor (Fibre Side down). Guide the Floorcleaner Head into one side of the Fibre. Click the ‘open’ lever and raise the Floorcleaner Head to guide into the opposite side pocket of the Floor Fibre, lowering the Floorcleaner Head and click the ‘close’ lever. Lift the yellow collar of the Floorcleaner, exposing the swivel joint. To adjust the height of the Telescopic Pole, gently twist the Telescopic Pole anti-clockwise to release, then raise to nose height and gently twist clockwise to secure at the desired height.
Step 3
Sweep using an 'S' motion to trap dust and debris into the Fibre. Note: Larger dirt particles will be collected into a pile for removal with a dust pan.
Step 4
To remove the Dust Floor Fibre, park your Floorcleaner by positioning the Floorcleaner collar down. Press the ‘open’ lever and lift Floorcleaner out of the Dust Floor Fibre. Shake Dust Floor Fibre outside to dispose of dust.